Before installing the customized pump foaming soap dispenser, it should be noted that not all tanks can be equipped with a customized pump foaming soap dispenser, and only those with a soap dispenser hole can be installed. Before installation, choose the type of customized pump foaming soap dispenser to match the hole of the soap dispenser. If the type is not correct, it cannot be installed. When installing, you only need to align the customized pump foaming soap dispenser with the soap dispenser hole and rotate it clockwise or counterclockwise. Just fix it. After installation, it can be checked whether the sink soap dispenser can be put into operation normally.

If the customized pump foaming soap dispenser is left aside for a period of time, there will be some condensation in the customized pump foaming soap dispenser. If the amount of the soap is small, stir it with warm water. This can restore the soap to liquid. Remove the soap, add warm water, and use the soap dispenser repeatedly until the warm water drains from the customized pump foaming soap dispenser, so that the entire soap dispenser can be cleaned. Please note that the dust and impurities in the soap will block the pump head. If you notice that the soap in the inner bottle has changed, please replace the soap. If the soap is too thick, the soap dispenser may not foam. In order to dilute the soap, a small amount of water agitation can be used.

When using the customized pump foaming soap dispenser for the first time, first use the clean water to expel the air inside, and then use the soap. When using the product for the first time, there may be some clean water in its inner bottle and pump head. This is not a quality problem of the product but is left over during the inspection of the customized pump foaming soap dispenser before leaving the factory.